Honda Prelude Master Cylinders and Parts
Your Honda Prelude needs new parts for its braking system. Having the right Honda Prelude parts is important. With a wide section of master cylinders and parts to choose from, you can find what you need for your Honda Prelude.
What does the master cylinder do for your Prelude?This component in your vehicle is a hydraulic pump in that is operated by your braking system. It converts physical pressure into hydraulic pressure that travels to the calipers. The force of this pressurized fluid is controlled by the amount force placed upon the pedal, so your Honda slows at a rate that you control.
How do you know if the master cylinder fails?Rubber is used to seal the pressurized fluid. Because rubber wears out over time, these seals deteriorate from constant use. Some common signs that the master cylinder needs replaced include:
- The pedal will feel spongy, mushy, or slowly lower itself to the floor.
- Your Hondas hydraulic fluid appears dark brown or black. Rubber seals that have worn out can mix with the fluid and reduce the functionality within the system.
- Your Preludes check engine light will come on. Honda Preludes have sensors within the system that gauge how much pressure it has.
There are a number of features to consider when choosing the right master cylinder for your Prelude:
- Master cylinder requirements are linked to pedal ratio based on 150 pounds of max force.
- Specs are a combination of values like the distance between push to mid-point, pivot point to master cylinder, and the force of push.
- A more powerful master cylinder means better braking during high-speed scenarios and the ability to brake with a lighter touch.
- To choose an adequate right master cylinder, choose one with at least the specs of the OEM version that came with your car originally.
Before replacing this part on your Prelude, be sure to check your Honda Prelude owners manual and identify all the parts you will be working on. You may need the following materials: the new part, hydraulic fluid, gloves, wrench, ratchet, safety glasses, vice, and rags.
- Drain the fluid from the reservoir on the top.
- Detach the fluid sensor connector from the plastic portion and remove any parts that are in the way.
- Drain and remove the lines.
- Remove the old part.
- In reverse order, install the new part in your Honda and reassemble the lines and remaining components.